Step 4: Rear seats removal
For the wiring to pass from behind to the front, you have to remove the rear seats and side panels. The process is relatively simple.
First you open the roof of the cabrio all the way down.
Then remove the piece from the backrest located in the center of the rear seats.
Pull the seat bench 1 into the front area upwards from the three slots 2 - arrows A.
Pull the seat bench at an angle of 45 ° from the slots in the back area to the outside and unscrew the screws 1 and 2..
Now to get the plastic caps behind the head restraints, pull the cover 1 upwards from the arrows slots.
Loosen the loop from the cover.
Pull up the back through the plastic sheets 3 and 4 in the area of the head restraints. It comes out of the way.
Now it is the the turn of the side wallpaper. Unscrew the one screw on the top, which is hidden next to the belt and the two screws at the bottom.
Now disconnect the cable harness from the speaker and pull the wallpaper up and in, it comes out easily. Be careful not to block the wallpaper from closing the roof and close the roof now. You can continue to work at another time.